User's Manual Part 3
Table Of Contents
- Chapter 9 Maintenance
- Chapter 10 Advanced Configuration
- Chapter 11 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Networks, Routing, and Firewall Basics
- Appendix C Preparing Your Network
- Appendix D Firewall Log Formats
- Appendix E Wireless Networking Basics
- Appendix F Virtual Private Networking
- Appendix G NETGEAR VPN Configuration FVS318 or FVM318 to FWG114P
- Appendix H NETGEAR VPN Configuration FVS318 or FVM318 with FQDN to FVS328
- Glossary
- Index
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Advanced Configuration 10-9
March 2004, 202-10027-01
Figure 10-3. Static Route Entry and Edit Menu
2. Type a route name for this static route in the Route Name box.
(This is for identification purpose only.)
3. Select Active to make this route effective.
4. Select Private if you want to limit access to the LAN only. The static route will not be reported
in RIP.
5. Type the Destination IP Address of the final destination.
6. Type the IP Subnet Mask for this destination.
If the destination is a single host, type 255.255.255.254.
7. Type the Gateway IP Address, which must be a router on the same LAN segment as the router.
8. Type a number between 1 and 15 as the Metric value.
This represents the number of routers between your network and the destination. Usually, a
setting of 2 or 3 works, but if this is a direct connection, set it to 1.
9. Click Apply to have the static route entered into the table.
As an example of when a static route is needed, consider the following case:
• Your primary Internet access is through a cable modem to an ISP.
• You have an ISDN router on your home network for connecting to the company where
you are employed. This router’s address on your LAN is 192.168.0.100.