User's Manual Part 2
Table Of Contents
- Chapter 7 Print Server
- Chapter 8 Virtual Private Networking
- Overview of FWG114P Policy-Based VPN Configuration
- Using Digital Certificates for IKE Auto-Policy Authentication
- Walk-Through of Configuration Scenarios on the FWG114P
- How to Use the VPN Wizard to Configure a VPN Tunnel
- Netgear VPN Client to FWG114P
- Step-By-Step Configuration of FWG114P Gateway
- Step-By-Step Configuration of the Netgear VPN Client
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
8-32 Virtual Private Networking
March 2004, 202-10027-01
Netgear VPN Client to FWG114P
Follow these procedures to configure a VPN tunnel from a NETGEAR ProSafe VPN Client to an
FWG114P. This case study follows the Virtual Private Network Consortium (VPNC)
interoperability profile guidelines. The menu options for the FVS328, FVL328, FWAG114, and
FWG114P are the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table 8-1. Summary
VPN Consortium Scenario: Scenario 1
Type of VPN PC/Client-to-Gateway
Security Scheme: IKE with Preshared Secret/Key (not Certificate-based)
Date Tested: December 2003
Model/Firmware Tested:
Gateway FWG114P firmware v 2.2
Client NETGEAR ProSafe VPN Client v10.1
IP Addressing:
Gateway Static IP address
Client Dynamic