User's Manual Part 2
Table Of Contents
- Chapter 7 Print Server
- Chapter 8 Virtual Private Networking
- Overview of FWG114P Policy-Based VPN Configuration
- Using Digital Certificates for IKE Auto-Policy Authentication
- Walk-Through of Configuration Scenarios on the FWG114P
- How to Use the VPN Wizard to Configure a VPN Tunnel
- Netgear VPN Client to FWG114P
- Step-By-Step Configuration of FWG114P Gateway
- Step-By-Step Configuration of the Netgear VPN Client
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Virtual Private Networking 8-23
March 2004, 202-10027-01
4. Set up the FWG114P VPN -Auto Policy illustrated below.
a. From the main menu VPN section, click on the VPN Policies link, and then click on the
Add Auto Policy button.
Figure 8-15: Scenario 1 VPN - Auto Policy
b. Configure the IKE Policy according to the settings in the illustration above and click
Apply to save your settings. For more information on IKE Policy topics, please see “IKE
Policies’ Automatic Key and Authentication Management” on page 8-3.
Note: Selecting ANY for the Traffic Selectors means all traffic goes through the IPSec
tunnel and prevents access to the Internet.
5. After applying these changes, all traffic from the range of LAN IP addresses specified on
FWG114P A and FWG114P B will flow over a secure VPN tunnel.
WAN IP
address
LAN IP
addresses