User's Manual Part 2
Table Of Contents
- Chapter 7 Print Server
- Chapter 8 Virtual Private Networking
- Overview of FWG114P Policy-Based VPN Configuration
- Using Digital Certificates for IKE Auto-Policy Authentication
- Walk-Through of Configuration Scenarios on the FWG114P
- How to Use the VPN Wizard to Configure a VPN Tunnel
- Netgear VPN Client to FWG114P
- Step-By-Step Configuration of FWG114P Gateway
- Step-By-Step Configuration of the Netgear VPN Client
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Virtual Private Networking 8-9
March 2004, 202-10027-01
VPN Policy Configuration for Manual Key Exchange
With Manual Key Management, you will not use an IKE policy. You must manually type in all the
required key information. Click the VPN Policies link from the VPN section of the main menu to
display the menu shown below.
Enable Encryption Use this checkbox to enable or disable ESP Encryption.
Encryption
Algorithm
If you enable ESP encryption, then select the encryption algorithm:
• DES is the default.
• 3DES is more secure.
Enable Authentication Use this checkbox to enable or disable ESP transform for this VPN policy.
You can also select the ESP mode with this menu.
Two ESP modes are available:
•Plain ESP
• ESP with authentication
Authentication
Algorithm
If you enable AH, then use this menu to select which authentication
algorithm will be employed.
The choices are:
• MD5 is the default.
• SHA1 is more secure.
NETBIOS Enable Check this if you wish NETBIOS traffic to be forwarded over the VPN
tunnel. The NETBIOS protocol is used by Microsoft Networking for such
features as Network Neighborhood.
Table 8-1. VPN Auto Policy Configuration Fields
Field Description