User's Manual Part 2
Table Of Contents
- Chapter 7 Print Server
- Chapter 8 Virtual Private Networking
- Overview of FWG114P Policy-Based VPN Configuration
- Using Digital Certificates for IKE Auto-Policy Authentication
- Walk-Through of Configuration Scenarios on the FWG114P
- How to Use the VPN Wizard to Configure a VPN Tunnel
- Netgear VPN Client to FWG114P
- Step-By-Step Configuration of FWG114P Gateway
- Step-By-Step Configuration of the Netgear VPN Client
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
7-6 Print Server
March 2004, 202-10027-01
Set up the Netgear printer port driver.
a. Click Finish when the Installation
Wizard is done.
The Printer Port Setup utility displays,
and queries the network to locate the
print server in the FWG114P.
After a short delay, the Printer Port
Setup utility will display the port it finds
in the FWG114P print server.
b. Click Add to add this printer port to your
computer.
The Printer Port Setup utility will report
that Port FWG114P_P1 has been added
to the computer.
c. Click Exit to exit the Printer Port Setup
utility.
The Windows Add Printer Wizard
automatically runs.
Netgear Printer Port Installation Wizard
Note: Under Windows 95, you may
receive an error message stating that
SETUPAPI.DLL was not found. In this
case, you should upgrade your Internet
Explorer to version 5 or later.
Netgear Printer Port Setup Utility