User's Manual Part 1
Table Of Contents
- Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Connecting the FWG114P to the Internet
- Chapter 4 Wireless Configuration
- Chapter 5 Serial Port Configuration
- Chapter 6 Firewall Protection and Content Filtering
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Wireless Configuration 4-7
March 2004, 202-10027-01
Default Factory Settings
The FWG114P default factory settings shown below. You can restore these defaults with the
Factory Default Restore button on the rear panel as seen in the illustration “FWG114P Rear Panel”
on page 2-8. After you install the FWG114P Wireless Firewall/Print Server, use the procedures
below to customize any of the settings to better meet your networking needs.
FEATURE DEFAULT FACTORY SETTINGS
SSID NETGEAR
RF Channel 11 until the region is selected
Access Point Enabled
SSID broadcast Enabled
Wireless Card Access List for
Access Point Connections
All wireless stations allowed
WEP Security Disabled
Authentication Type Open System