User's Manual
Table Of Contents
- Reference Manual for the Model FWAG114 Cable/ DSL Wireless ProSafe Firewall
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Firewall Protection and Content Filtering
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Observe Performance, Placement, and Range Guidelines
- Implement Appropriate Wireless Security
- Understanding Wireless Settings
- Chapter 4 Firewall Protection and Content Filtering
- Firewall Protection and Content Filtering Overview
- Block Sites
- Using Rules to Block or Allow Specific Kinds of Traffic
- Services
- Using a Schedule to Block or Allow Specific Traffic
- Getting E-Mail Notifications of Event Logs and Alerts
- Viewing Logs of Web Access or Attempted Web Access
- Configuring E-Mail Alert and Web Access Log Notifications
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the Model FWAG114 Cable/DSL Wireless ProSafe Firewall
6-12 Advanced Configuration
When you first configured your router, two implicit static routes were created. A default route was
created with your ISP as the gateway, and a second static route was created to your local network
for all 192.168.0.x addresses. With this configuration, if you attempt to access a device on the
134.177.0.0 network, your router will forward your request to the ISP. The ISP forwards your
request to the company where you are employed, and the request will likely be denied by the
company’s firewall.
In this case you must define a static route, telling your router that 134.177.0.0 should be accessed
through the ISDN router at 192.168.0.100. The static route would look like
Figure 6-5.
In this example:
• The Destination IP Address and IP Subnet Mask fields specify that this static route applies to
all 134.177.x.x addresses.
• The Gateway IP Address fields specifies that all traffic for these addresses should be
forwarded to the ISDN router at 192.168.0.100.
• A Metric value of 1 will work since the ISDN router is on the LAN.
• Private is selected only as a precautionary security measure in case RIP is activated.
Enabling Remote Management Access
Using the Remote Management page, you can allow a user or users on the Internet to configure,
upgrade and check the status of your FWAG114 wireless firewall.
To configure your router for Remote Management:
1. Select the Turn Remote Management On check box.
2. Specify what external addresses will be allowed to access the router’s remote management.
Note: For enhanced security, restrict access to as few external IP addresses as practical.
a. To allow access from any IP address on the Internet, select Everyone.
b. To allow access from a range of IP addresses on the Internet, select IP address range.
Enter a beginning and ending IP address to define the allowed range.
Note: Be sure to change the router's default configuration password to a very secure password. The ideal
password should contain no dictionary words from any language, and should be a mixture of letters (both
upper and lower case), numbers, and symbols. Your password can be up to 30 characters.