User's Manual
Table Of Contents
- Reference Manual for the Model FWAG114 Cable/ DSL Wireless ProSafe Firewall
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Firewall Protection and Content Filtering
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Observe Performance, Placement, and Range Guidelines
- Implement Appropriate Wireless Security
- Understanding Wireless Settings
- Chapter 4 Firewall Protection and Content Filtering
- Firewall Protection and Content Filtering Overview
- Block Sites
- Using Rules to Block or Allow Specific Kinds of Traffic
- Services
- Using a Schedule to Block or Allow Specific Traffic
- Getting E-Mail Notifications of Event Logs and Alerts
- Viewing Logs of Web Access or Attempted Web Access
- Configuring E-Mail Alert and Web Access Log Notifications
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the Model FWAG114 Cable/DSL Wireless ProSafe Firewall
6-6 Advanced Configuration
Using the LAN IP Setup Options
The second feature category under the Advanced heading is LAN IP Setup. This menu allows
configuration of LAN IP services such as DHCP and RIP. From the Main Menu of the browser
interface, under Advanced, click on LAN IP Setup to view the LAN IP Setup menu, shown below.
Figure 6-3: LAN IP Setup Menu
Configuring LAN TCP/IP Setup Parameters
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act.as a
DHCP server. The router’s default LAN IP configuration is:
• LAN IP addresses—192.168.0.1
• Subnet mask—255.255.255.0
These addresses are part of the IETF-designated private address range for use in private networks,
and should be suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in this menu.