User's Manual
Table Of Contents
- Reference Manual for the Model FWAG114 Cable/ DSL Wireless ProSafe Firewall
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Firewall Protection and Content Filtering
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Observe Performance, Placement, and Range Guidelines
- Implement Appropriate Wireless Security
- Understanding Wireless Settings
- Chapter 4 Firewall Protection and Content Filtering
- Firewall Protection and Content Filtering Overview
- Block Sites
- Using Rules to Block or Allow Specific Kinds of Traffic
- Services
- Using a Schedule to Block or Allow Specific Traffic
- Getting E-Mail Notifications of Event Logs and Alerts
- Viewing Logs of Web Access or Attempted Web Access
- Configuring E-Mail Alert and Web Access Log Notifications
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the Model FWAG114 Cable/DSL Wireless ProSafe Firewall
Connecting the Firewall to the Internet 2-11
Fixed IP Account Wizard-Detected Option
If the Setup Wizard discovers that your ISP uses Fixed IP assignment, you will see this menu:
Figure 2-10: Setup Wizard menu for Fixed IP address accounts
• Fixed IP is also called Static IP. Enter your assigned IP Address, Subnet Mask, and the IP
Address of your ISP’s gateway router. This information should have been provided to you by
your ISP. You will need the configuration parameters from your ISP you recorded in
“Record
Your Internet Connection Information” on page 2-3
.
• Enter the IP address of your ISP’s Primary and Secondary DNS Server addresses.
Note: Restart the computers on your network so that these settings take effect.
• Click Apply to save the settings.
• Click Test to test your Internet connection. If the NETGEAR website does not appear within
one minute, refer to
Chapter 7, “Troubleshooting.”