User's Manual
Table Of Contents
- Reference Manual for the Model FWAG114 Cable/ DSL Wireless ProSafe Firewall
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Firewall Protection and Content Filtering
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Observe Performance, Placement, and Range Guidelines
- Implement Appropriate Wireless Security
- Understanding Wireless Settings
- Chapter 4 Firewall Protection and Content Filtering
- Firewall Protection and Content Filtering Overview
- Block Sites
- Using Rules to Block or Allow Specific Kinds of Traffic
- Services
- Using a Schedule to Block or Allow Specific Traffic
- Getting E-Mail Notifications of Event Logs and Alerts
- Viewing Logs of Web Access or Attempted Web Access
- Configuring E-Mail Alert and Web Access Log Notifications
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the Model FWAG114 Cable/DSL Wireless ProSafe Firewall
1-6 Introduction
The Firewall’s Front Panel
The front panel of the FWAG114 wireless firewall contains the status LEDs described below.
Figure 1-1: FWAG114 Front Panel
You can use some of the LEDs to verify connections. Viewed from left to right,
Table 1-1
describes the LEDs on the front panel of the router. These LEDs are green when lit.
The Firewall’s Rear Panel
The rear panel of the FWAG114 wireless firewall contains the port connections listed below.
Table 1-1. LED Descriptions
Label Activity Description
POWER On Power is supplied to the firewall.
TEST On
Off
The system is initializing.
The system is ready and running.
INTERNET
100 (100 Mbps) On
Off
The Internet (WAN) port is operating at 100 Mbps.
The Internet (WAN) port is operating at 10 Mbps.
LINK/ACT
(Link/Activity)
On
Blinking
The Internet port has detected a link with an attached device.
Data is being transmitted or received by the Internet port.
LOCAL
100 (100 Mbps) On
Off
The Local port is operating at 100 Mbps.
The Local port is operating at 10 Mbps.
LINK/ACT
(Link/Activity)
On
Blinking
The Local port has detected a link with an attached device.
Data is being transmitted or received by the Local port.
WLAN On The Wireless (WLAN) port is operating.
need product front panel photo