User's Manual
Table Of Contents
- Reference Manual for the Model FWAG114 Cable/ DSL Wireless ProSafe Firewall
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Firewall Protection and Content Filtering
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Firewall to the Internet
- Chapter 3 Wireless Configuration
- Observe Performance, Placement, and Range Guidelines
- Implement Appropriate Wireless Security
- Understanding Wireless Settings
- Chapter 4 Firewall Protection and Content Filtering
- Firewall Protection and Content Filtering Overview
- Block Sites
- Using Rules to Block or Allow Specific Kinds of Traffic
- Services
- Using a Schedule to Block or Allow Specific Traffic
- Getting E-Mail Notifications of Event Logs and Alerts
- Viewing Logs of Web Access or Attempted Web Access
- Configuring E-Mail Alert and Web Access Log Notifications
- Chapter 5 Maintenance
- Chapter 6 Advanced Configuration
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Network, Routing, Firewall, and Basics
- Appendix C Preparing Your Network
- Appendix D Wireless Networking Basics
- Glossary
- Index
Reference Manual for the Model FWAG114 Cable/DSL Wireless ProSafe Firewall
C-4 Preparing Your Network
If you need Client for Microsoft Networks:
a. Click the Add button.
b. Select Client, and then click Add.
c. Select Microsoft.
d. Select Client for Microsoft Networks, and then click OK.
3. Restart your PC for the changes to take effect.
Enabling DHCP to Automatically Configure TCP/IP Settings in
Windows 95B, 98, and Me
After the TCP/IP protocol components are installed, each PC must be assigned specific
information about itself and resources that are available on its network. The simplest way to
configure this information is to allow the PC to obtain the information from a DHCP server in the
network.
You will find there are many similarities in the procedures for different Windows systems
when using DHCP to configure TCP/IP.
The following steps will walk you through the configuration process for each of these
versions of Windows.
Locate your Network Neighborhood icon.
• If the Network Neighborhood icon is on the Windows desktop, position your mouse
pointer over it and right-click your mouse button.
• If the icon is not on the desktop,
•Click Start on the task bar located at the bottom left of the window.
• Choose Settings, and then Control Panel.
• Locate the Network Neighborhood icon and click on it. This will open the Network
panel as shown below.