Manualshelf

Quick Reference Guide

ManualsBrandsNetgear ManualsPC ComponentsNetgear FVX538v1
101102103104105106107108109110
ProSafe VPN Firewall 200 FVX538 Reference Manual
5-4 Virtual Private Networking
v1.0, March 2009
1. Select VPN > IPsec VPN > VPN Wizard to display the VPN Wizard tab page.
To view the wizard default settings, click the VPN Default values link. You can modify these
settings after completing the wizard.
2. Select Gateway as your connection type.
3. Create a Connection Name. Enter a descriptive name for the connection. This name used to
help you manage the VPN settings; is not supplied to the remote VPN endpoint.
4. Enter a Pre-shared Key. The key must be entered both here and on the remote VPN gateway,
or the remote VPN client. This key must be a minimum of 8 characters and should not exceed
49 characters.
5. Choose which WAN port to use as the VPN tunnel end point.
6. Enter the Remote and Local WAN IP Addresses or Internet Names of the gateways which
will connect.
Figure 5-4
Note: If you are using a dual WAN rollover configuration, after completing the
wizard, you must manually update the VPN policy to enable VPN rollover.
This allows the VPN tunnel to roll over when the WAN Mode is set to Auto
Rollover. The wizard will not set up the VPN policy with rollover enabled.