Quick Reference Guide

ProSafe VPN Firewall 50 FVS338 Reference Manual
B-4 System Logs and Error Messages
v1.0, January 2010
IPSec Restart
This logging is always done.
WAN Status
This section describes the logs generated by the WAN component.
If there are two ISP links for Internet connectivity, the VPN firewall can be configured in Auto
Rollover Mode.
Auto Rollover
When WAN mode is configured to Auto Rollover, primary link is active and secondary acts as a
backup. When primary link goes down, secondary becomes active until primary comes up. The
device monitors the status of the primary link by the configured WAN Failure Detection method.
This section describes the logs generated when the WAN mode is set to auto rollover.
Table B-7. System Logs: IPSec Restart
Message Jan 23 16:20:44 [FVS338] [wand] [IPSEC] IPSEC Restarted
Explanation Log generated when the IPSEC is restarted.
This log is logged when IPSEC restarts after applying any changes in the
configuration.
Recommended Action None
System Logs: WAN Status, Auto Rollover
Message Nov 17 09:59:09 [FVS338] [wand] [LBFO] WAN1 Test Failed 1 of 3 times_
Nov 17 09:59:39 [FVS338] [wand] [LBFO] WAN1 Test Failed 2 of 3 times_
Nov 17 10:00:09 [FVS338] [wand] [LBFO] WAN1 Test Failed 3 of 3 times_
Nov 17 10:01:01 [FVS338] [wand] [LBFO] WAN1 Test Failed 4 of 3 times_
Nov 17 10:01:35 [FVS338] [wand] [LBFO] WAN1 Test Failed 5 of 3 times_
Nov 17 10:01:35 [FVS338] [wand] [LBFO] WAN1(DOWN), WAN2(UP),
ACTIVE(WAN2)_
Nov 17 10:02:25 [FVS338] [wand] [LBFO] WAN1 Test Failed 6 of 3 times_
Nov 17 10:02:25 [FVS338] [wand] [LBFO] Restarting WAN1_
Nov 17 10:02:57 [FVS338] [wand] [LBFO] WAN1 Test Failed 7 of 3 times_
Nov 17 10:03:27 [FVS338] [wand] [LBFO] WAN1 Test Failed 8 of 3 times_
Nov 17 10:03:57 [FVS338] [wand] [LBFO] WAN1 Test Failed 9 of 3 times_
Nov 17 10:03:57 [FVS338] [wand] [LBFO] Restarting WAN1_