Quick Reference Guide

ProSafe VPN Firewall 50 FVS338 Reference Manual
VPN Firewall and Network Management 6-21
v1.0, January 2010
6. Locate the downloaded file and click upload. This will start the software upgrade to your VPN
firewall. The software upgrade process might take some time. At the conclusion of the
upgrade, your VPN firewall will reboot.
7. After the VPN firewall has rebooted, select Monitoring to display the Router Status screen,
and confirm the new firmware version to verify that your VPN firewall now has the new
software installed.
Configuring Date and Time Service
Date, time and NTP Server designations can be configured on the Time Zone screen. Network
Time Protocol (NTP) is a protocol that is used to synchronize computer clock times in a network
of computers.
To set time, date and NTP servers:
1. Select Administration from the main menu and Time Zone from the submenu. The Time
Zone screen will display (see Figure 6-9 on page 6-22).
Warning: After you have clicked upload, do not try to go online, turn off the VPN
firewall, shutdown the computer or do anything else to the VPN firewall
until the VPN firewall finishes the upgrade! When the Test light turns off,
wait a few more seconds before doing anything.
Note: In some cases, such as a major upgrade, it may be necessary to erase the
configuration and manually reconfigure your VPN firewall after upgrading it.
Refer to the Release Notes included with the software to find out if this is
required.