Quick Reference Guide

ProSafe VPN Firewall 50 FVS338 Reference Manual
Virtual Private Networking 5-7
v1.0, January 2010
2. Select VPN Client as your VPN tunnel connection.
3. Create a Connection Name such as “Client to GW1”. This descriptive name is not supplied to
the remote VPN client; it is only for your reference.
4. Enter a Pre-shared Key; in this example, we are using r3m0+eC1ient, which must also be
entered in the VPN client software. The key length must be 8 characters minimum and cannot
exceed 49 characters.
5. Choose which WAN port to use as the VPN tunnel end point.
Figure 5-7
Note: If you are using a dual WAN rollover configuration, after completing the wiz-
ard, you must manually update the VPN policy to enable VPN rollover. This
allows the VPN tunnel to roll over when the WAN Mode is set to Auto Roll-
over. The wizard will not set up the VPN policy with rollover enabled.