Quick Reference Guide

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
Virtual Private Networking Using IPsec 5-3
v1.0, January 2010
Using the VPN Wizard for Client and Gateway Configurations
You use the VPN Wizard to configure multiple gateway or client VPN tunnel policies.
The section below provides wizard and NETGEAR VPN Client configuration procedures for the
following scenarios:
• Using the wizard to configure a VPN tunnel between 2 VPN gateways
• Using the wizard to configure a VPN tunnel between a VPN gateway and a VPN client
Configuring a VPN tunnel connection requires that all settings and parameters on both sides of the
VPN tunnel match or mirror each other precisely, which can be a daunting task. The VPN Wizard
efficiently guides you through the setup procedure with a series of questions that will determine
the IPsec keys and VPN policies it sets up. The VPN Wizard will also set the parameters for the
network connection: Security Association, traffic selectors, authentication algorithm, and
encryption. The parameters used by the VPN wizard are based on the recommendations of the
VPN Consortium (VPNC), an organization that promotes multi-vendor VPN interoperability.
Creating Gateway to Gateway VPN Tunnels with the Wizard
Follow these steps to set up a gateway VPN tunnel using the VPN Wizard.
1. Select VPN > IPsec VPN from the menu.
2. Click the VPN Wizard tab to display the VPN Wizard screen (see Figure 5-4 on page 5-4).
To view the wizard default settings, click the VPN Wizard Default Values link. You can
modify these settings after completing the wizard.
Figure 5-3