Quick Reference Guide

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
Connecting the FVS336G to the Internet 2-9
v1.0, January 2010
b. Configure the following fields:
• Account Name. Valid account name for the PPPoE connection.
• Domain Name. Name of your ISP’s domain or your domain name if your ISP has
assigned one. In most cases, you may leave this field blank.
• Idle Timeout. Select Keep Connected, to keep the connection always on. To logout
after the connection is idle for a period of time, click Idle Time and in the timeout
field enter the number of minutes to wait before disconnecting.
• Connection Reset. Select this checkbox to to specify a time when the PPPoE WAN
connection is reset, that is, the connection is disconnected momentarily and then re-
established. Enter the hour and minutes in the Disconnect Time fields to specify when
the connection should be disconnected. Enter the seconds in the Delay field to specify
the period after which the connection should be re-established.
6. If your ISP is Austria Telecom or any other ISP that uses PPTP as a login protocol:
a. Select PPTP.
b. Configure the following fields:
• Account Name (also known as Host Name or System Name). Enter the valid account
name for the PPTP connection (usually your e-mail name as assigned by your ISP).
Some ISPs require entering your full e-mail address here.
• Domain Name. Your domain name or workgroup name assigned by your ISP, or your
ISPs domain name. You may leave this field blank.
• Idle Timeout. Check the Keep Connected radio button to keep the connection
always on. To logout after the connection is idle for a period of time, click Idle Time
and enter the number of minutes to wait before disconnecting in the timeout field. This
is useful if your ISP charges you based on the amount of time you have logged in.
• My IP Address. IP address assigned by the ISP to make the connection with the ISP
server.
• Server IP Address. IP address of the PPTP server.