Quick Reference Guide

Model FVS328 ProSafe VPN Firewall with Dial Back-up Reference Manual
Virtual Private Networking 7-15
May 2004, 202-10031-01
How to Use the VPN Wizard to Configure a VPN Tunnel
Follow this procedure to configure a VPN tunnel using the VPN Wizard.
Note: The LAN IP address ranges of each VPN endpoint must be different. The connection will
fail if both are using the NETGEAR default address range of 192.168.0.x.
1. Log in to the FVS318 on LAN A at its default LAN address of http://192.168.0.1 with its
default user name of
admin and password of password. Click the VPN Wizard link in the
main menu to display this screen. Click Next to proceed.
Figure 7-5: VPN Wizard Start Screen
2.
Fill in the Connection Name, pre-shared key, and select the type of target end point, and click
Next to proceed.
Note: If you have turned NAT off, before configuring VPN IPSec tunnels you must first
open UDP port 500 for inbound traffic as explained in “Example: Port Forwarding for
VPN Tunnels when NAT is Off” on page 6-10.