Quick Reference Guide
Model FVS328 ProSafe VPN Firewall with Dial Back-up Reference Manual
Connecting the FVS328 to the Internet 3-5
May 2004, 202-10031-01
Warning: Failure to restart your network in the correct sequence could prevent you from
connecting to the Internet.
a. First, turn on the broadband modem and wait 2 minutes.
b. Now, turn on your firewall.
c. Last, turn on your computer.
Note: If software usually logs you in to the Internet, do not run that software or cancel it if
it starts automatically.
Figure 3-1: FVS328 status lights
Check the status lights and verify the following:
• Power: The power light goes on when your turn the firewall on.
• Test: The Test light turns on, blinks, then goes off solid after less than a minute.
• Internet: The Internet light on the firewall is lit. If the Internet light is not lit, make sure the
Ethernet cable is securely attached to the firewall Internet port and the powered on
modem.
• Local: A Local light on the router is lit. If no Local lights are lit, check that the Ethernet
cable connecting the powered on computer to the router is securely attached at both ends.
).4%2.%4
,/#!,
!#4
,.+
,.+!#4
"ROADBAND
0RO3AFE60.&IREWALLWITH$IAL"ACKUP
-/$%,
&63
072 4%34 -ODEM
Power
Internet
Local Port 6
Test