Quick Reference Guide

ProSafe VPN Firewall FVS318v3 Reference Manual
Basic Virtual Private Networking 4-29
v5.0, January 2012
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type ping -t 192.168.3.1
and then click OK.
Figure 4-34
This will cause a continuous ping to be sent to the first FVS318v3. Within two minutes,
the ping response should change from “timed out” to “reply.”
Note: Use Ctrl-C to stop the pinging.
Figure 4-35
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote FVS318v3. After a short wait, you should see the login screen of the
VPN Firewall (unless another PC already has the FVS318v3 management interface open).
• Gateway-to-Gateway Configuration. Test the VPN tunnel by pinging the remote network
from a PC attached to the FVS318v3.
a. Open a command prompt (Start -> Run -> cmd).
b. Type ping 192.168.3.1.