Quick Reference Guide

ProSafe VPN Firewall FVS318v3 Reference Manual
4-6 Basic Virtual Private Networking
v5.0, January 2012
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
FVS318v3
This section uses the VPN Wizard to set up the VPN tunnel using the VPNC default parameters
listed in Table 4-1 on page -4. If you have special requirements not covered by these VPNC-
recommended parameters, refer to Chapter 5, “Advanced Virtual Private Networking” to set up the
VPN tunnel.
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
1. Log in to the FVS318v3 at its LAN address of http://192.168.0.1 with its default user name of
admin and password of password. Click the VPN Wizard link in the main menu to display
this screen. Click Next to proceed.
Figure 4-4
2. Fill in the Connection Name and the pre-shared key, select the type of target end point, and
click Next to proceed.
Note: The Connection Name is arbitrary and not relevant to how the configuration
functions.