Quick Reference Guide

ProSafe VPN Firewall FVS318v3 Reference Manual
Basic Virtual Private Networking 4-5
v5.0, January 2012
VPN Tunnel Configuration
There are two tunnel configurations and three ways to configure them:
• Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
– See “Setting Up a Client-to-Gateway VPN Configuration” on page 4-5.
– See “Setting Up a Gateway-to-Gateway VPN Configuration” on page 4-21.
• See Chapter 5, “Advanced Virtual Private Networking” when the VPN Wizard and its VPNC
defaults (see Table 4-1 on page 4-4) are not appropriate for your special circumstances.
Setting Up a Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway (see Figure 4-3) involves the following two steps:
• “Step 1: Configuring the Client-to-Gateway VPN Tunnel on the FVS318v3” on page 4-6 uses
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
• “Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC” on page 4-9
configures the NETGEAR ProSafe VPN Client endpoint.
Figure 4-3
192.168.3.1
VPN Tunnel
FVS318v3
24.0.0.1
PC
(Running NETGEAR
ProSafe VPN Client)
PCs