Quick Reference Guide

Reference Manual for the Model FVS318 Broadband ProSafe VPN Firewall
6-12 Virtual Private Networking
M-10146-01
1. Set up the two LANs to have different IP address ranges.
Note: The LAN IP address ranges of each connected network must be different. The
connection will fail if both are using the NETGEAR default address range of 192.168.0.x.
This procedure uses the settings in the configuration worksheet above. A blank worksheet you
can use to record your settings is provided on page 6-31.
a. Log in to the FVS318 on LAN A at its default LAN address of http://192.168.0.1 with its
default user name of
admin and password of password. Click the LAN IP Setup link in
the main menu Advanced section to display the LAN TCP/IP Setup menu shown below.
Figure 6-7: Configuring the Local LAN (A) via the LAN IP Setup Menu
b.
For this example, configure the FVS318 settings on LANs A and B as follows:
Note: If port forwarding, trusted user, or static routes are set up, you will need to change
these configurations to match the 192.168.3.x network as well.
c. Click Apply. Because you changed the Firewall’s IP address, you are now disconnected.
Network Configuration Settings
Network LAN IP Address Subnet Mask FQDN or Gateway IP
(WAN IP Address)
LAN A
192.168.3.1 255.255.255.0 24.0.0.1
LAN B
192.168.0.1 255.255.255.0 10.0.0.1
LAN A
LAN B