User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Security Mode Configuration Commands
98
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
prefer. However, note that the setting of the action keyword determines which other
keywords and parameters can you can apply to a rule.
Step 1 Format security firewall ipv4 add_rule dmz_wan inbound
Mode security
Step 2 Format service_name {default_services <default service name> |
{custom_services <custom service name>}
action {ALWAYS_BLOCK | ALWAYS_ALLOW |
BLOCK_BY_SCHEDULE_ELSE_ALLOW {schedule {Schedule1 |
Schedule2 | Schedule3}} | ALLOW_BY_SCHEDULE_ELSE_BLOCK
{schedule {Schedule1 | Schedule2 | Schedule3}}}
send_to_dmz_server_ip <ipaddress>
translate_to_port_number enable {N | Y
{translate_to_port_number port <number>}}
wan_destination_ip_address {WAN | OTHERS
{wan_destination_ip_address_start <ipaddress>}
dmz_users {ANY | SINGLE_ADDRESS {dmz_user_start_ip <ipaddress>}
| ADDRESS_RANGE {dmz_user_start_ip <ipaddress>}
{dmz_user_end_ip <ipaddress>}}
wan_users {ANY | SINGLE_ADDRESS {wan_user_start_ip <ipaddress>}
| ADDRESS_RANGE {wan
_user_start_ip <ipaddress>}
{wan_user_end_ip <ipaddress>}}
log {NEVER | ALWAYS}
Mode security-config [firewall-ipv4-dmz-wan-inbound]