User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Security Mode Configuration Commands
91
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example: See the command example for the security firewall ipv4 add_rule lan_wan
inbound command.
Related show command: show security firewall ipv4 setup lan_wan
security firewall ipv4 add_rule dmz_wan outbound
This command configures a new IPv4 DMZ WAN outbound firewall rule. After you have
issued the security firewall ipv4 add_rule dmz_wan outbound command, you
enter the security-config [firewall-ipv4-dmz-wan-outbound] mode, and then you can configure
lan_user_end_ip ipaddress The end IP address if the
lan_users address_wise
keywords are set to
ADDRESS_RANGE.
lan_users group_wise group name The name of the LAN group. The
group name is either a default
name (Group1, Group2, Group3,
and so on) or a custom name that
you specified with the net lan
lan_groups edit <row id> <new
group name> command.
For an inbound rule, this option is
available only when the WAN mode
is Classical Routing.
wan_user ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
The type of WAN address.
wan_user_start_ip ipaddress There are two options:
• The IP address if the wan_user
keyword is set to
SINGLE_ADDRESS.
• The start IP address if the
wan_user keyword is set to
ADDRESS_RANGE.
wan_user_end_ip ipaddress The end IP address if the
wan_user keyword is set to
ADDRESS_RANGE.
Logging and bandwidth profile
log NEVER or ALWAYS Enables or disables logging.
bandwidth_profile profile name The profile that you have
configured with the security
bandwidth profile add command.
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description