User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Security Mode Configuration Commands
90
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
translate_to_port_number
enable
Y or N Enables or disables port
forwarding.
translate_to_port_number
port
number The port number (integer) if port
forwarding is enabled. Valid
numbers are 0 through 65535.
wan_destination_ip_address
WAN, OTHERS, or RANGE The type of destination WAN
address for an inbound rule:
• WAN. The default IP address of
the WAN (broadband) interface.
• OTHERS. Another public IP
address, which you need to
configure by issuing the
wan_destination_ip_address_start
keyword and specifying an IPv4
address.
• RANGE. A range of public IP
addresses, which you need to
configure by issuing the
wan_destination_ip_address_start
and
wan_destination_ip_address_end
keywords and specifying IPv4
addresses.
wan_destination_ip_address_start
ipaddress There are two options:
• The IP address if the
wan_destination_ip_address
keyword is set to OTHERS.
• The start IP address if the
wan_destination_ip_address
keyword is set to RANGE.
wan_destination_ip_address_end
ipaddress The end IP address if the
wan_destination_ip_address
keyword is set to RANGE.
LAN user addresses or LAN group and WAN user addresses
lan_user address_wise ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
The type of LAN address.
For an inbound rule, this option is
available only when the WAN mode
is Classical Routing.
lan_user_start_ip ipaddress There are two options:
• The IP address if the lan_users
address_wise keywords are
set to SINGLE_ADDRESS.
• The start IP address if the
lan_users address_wise
keywords are set to
ADDRESS_RANGE.
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description