User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Security Mode Configuration Commands
78
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
prefer. However, note that the setting of the action keyword determines which other
keywords and parameters can you can apply to a rule.
Step 1 Format security firewall ipv4 add_rule lan_wan outbound
Mode security
Step 2 Format service_name {default_services <default service name> |
{custom_services <custom service name>}
action {ALWAYS_BLOCK | ALWAYS_ALLOW |
BLOCK_BY_SCHEDULE_ELSE_ALLOW {schedule {Schedule1 |
Schedule2 | Schedule3}} | ALLOW_BY_SCHEDULE_ELSE_BLOCK
{schedule {Schedule1 | Schedule2 | Schedule3}}}
lan_users {address_wise {ANY | SINGLE_ADDRESS {lan_user_start_ip
<ipaddress>} | ADDRESS_RANGE {lan_user_start_ip <ipaddress>}
{lan_user_end_ip <ipaddress>}} | group_wise <group name>}
wan_users {ANY | SINGLE_ADDRESS {wan_user_start_ip <ipaddress>}
| ADDRESS_RANGE {wan_user_start_ip <ipaddress>}
{wan_user_end_ip <ipaddress>}}
qos_priority {Normal-Service | Minimize-Cost |
Maximize-Reliability | Maximize-Throughput | Minimize
-Delay}
log {NEVER | ALWAYS}
bandwidth_profile <profile name>
nat_ip type {WAN_INTERFACE_ADDRESS | SINGLE_ADDRESS
{address <ipaddress>}}
Mode security-config [firewall-ipv4-lan-wan-outbound]