User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
73
4
4. Security Mode Configuration
Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
security mode. The chapter includes the following sections:
• Security Services Commands
• Security Schedules Commands
• IPv4 Add Firewall Rule and Edit Firewall Rule Commands
• IPv4 General Firewall Commands
• IPv6 Firewall Commands
• Attack Check Commands
• Session Limit, Time-Out, and Advanced Commands
• Address Filter and IP/MAC Binding Commands
• Port Triggering Commands
• UPnP Command
• Bandwidth Profile Commands
• Content Filtering Commands
IMPORTANT:
After you have issued a command that includes the word
configure, add, or edit, you need to save (or cancel) your
changes. For more information, see Save Commands on page 13.
Security Services Commands
security services add
This command configures a new firewall custom service. After you have issued the
security services add command, you enter the security-config [custom-service] mode,
and then you can configure one keyword and associated parameter or associated keyword
at a time in the order that you prefer.