User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
7
1
1. Introduction
This document describes the command-line interface (CLI) for the NETGEAR ProSafe
Wireless-N 8-Port Gigabit VPN Firewall FVS318N.
This chapter introduces the CLI interface. It includes the following sections:
• Command Syntax and Conventions
• The Four Categories of Commands
• The Five Main Modes for Configuration Commands
• Global Commands
• The Three Basic Types of Commands
• Command Autocompletion and Command Abbreviation
• Access the CLI
Note: For more information about the topics covered in this manual, visit
the support website at http://support.netgear.com.
Note: For more information about the features that you can configure
using the CLI, see the ProSafe Wireless-N 8-port Gigabit VPN
Firewall FVS318N Reference Manual.
Note: You cannot generate and upload a certificate through the CLI. You
need to access the web management interface to manage these
tasks.