User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
67
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
net-config[static-routing-ipv4]>
subnet_mask 255.255.255.0
net-config[static-routing-ipv4]>
interface wan
net-config[static-routing-ipv4]>
gateway_address 10.192.44.13
net-config[static-routing-ipv4]>
metric 7
net-config[static-routing-ipv4]>
save
Related show command: show net routing static ipv4 setup
net routing static ipv4 delete <route name>
This command deletes a static IPv4 route by deleting its name.
Related show command: show net routing static ipv4 setup
net routing static ipv4 delete_all
This command deletes all static IPv4 routes.
Related show command: show net routing static ipv4 setup
net routing dynamic configure
This command configures RIP and the associated MD5 key information. After you have
issued the net routing dynamic configure command, you enter the
net-config [dynamic-routing] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
Format net routing static ipv4 delete <route name>
Mode net
Format net routing static ipv4 delete_all
Mode net
Step 1 Format net routing dynamic configure
Mode net