User's Manual

Net Mode Configuration Commands
63
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N> net radvd configure dmz
net-config[radvd]> enable Y
net-config[radvd]> mode Unicast-Only
net-config[radvd]> flags Managed
net-config[radvd]> preference High
net-config[radvd]> mtu 1500
net-config[radvd]> life_time 7200
net-config[radvd]> save
Related show command: show net radvd dmz setup
net radvd pool dmz add
This command configures the IPv6 RADVD pool of advertisement prefixes for the DMZ. After
you have issued the net radvd pool dmz add command, you enter the
net-config [radvd-pool-dmz] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
flags Managed or Other Sets the flag:
• Managed. Specifies that the DHCPv6 stateful
protocol is used for autoconfiguration of the
address.
• Other. Specifies that the DHCPv6 stateful
protocol is used for autoconfiguration of other
(that is, nonaddress) information.
preference Low, Medium, or High The wireless VPN firewall’s preference in relation
to other hosts and routers in the DMZ.
mtu number The MTU size (integer) that is used in the RAs to
ensure that all nodes in the network use the same
MTU size. The default is 1500 seconds.
life_time seconds The advertisement lifetime in seconds (integer) of
the route. The default is 3600 seconds.
Step 1 Format net radvd pool dmz add
Mode net
Step 2 Format prefix_type {6To4 {sla_id <ID number>} | Global-Local-ISATAP
{prefix_address <ipv6-address>} {prefix_length
<prefix length>}}
prefix_life_time <seconds>
Mode net-config [radvd-pool-dmz]
Keyword (might consist
of two separate words)
Associated Keyword to
Select or Parameter to Type
Description