User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
55
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N>
net radvd configure lan
net-config[radvd]>
enable Y
net-config[radvd]>
mode Unsolicited-Multicast
net-config[radvd]>
interval 60
net-config[radvd]>
flags Managed
net-config[radvd]>
preference Medium
net-config[radvd]>
mtu 1496
net-config[radvd]>
life_time 7200
net-config[radvd]>
save
Related show command: show net radvd lan setup
net radvd pool lan add
This command configures the IPv6 RADVD pool of advertisement prefixes for the LAN. After
you have issued the net radvd pool lan add command, you enter the
net-config [radvd-pool-lan] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
interval seconds The interval in seconds (integer) between
unsolicited multicast RAs. Enter a period from 10
to 1800 seconds. The default is 30 seconds.
flags Managed or Other Sets the flag:
• Managed. Specifies that the DHCPv6 stateful
protocol is used for autoconfiguration of the
address.
• Other. Specifies that the DHCPv6 stateful
protocol is used for autoconfiguration of other
(that is, nonaddress) information.
preference Low, Medium, or High The wireless VPN firewall’s preference in relation
to other hosts and routers in the LAN.
mtu number The MTU size (integer) that is used in the RAs to
ensure that all nodes in the network use the same
MTU size. The default is 1500 seconds.
life_time seconds The advertisement lifetime in seconds (integer) of
the route. The default is 3600 seconds.
Step 1 Format net radvd pool lan add
Mode net
Keyword (might consist
of two separate words)
Associated Keyword to
Select or Parameter to Type
Description