User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
54
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
net lan ipv6 multi_homing delete <row id>
This command deletes a secondary IPv6 address by specifying its row ID.
Related show command: show net lan ipv6 multiHoming
net radvd configure lan
This command configures the Router Advertisement Daemon (RADVD) for the link-local
advertisements of IPv6 router addresses and prefixes in the LAN. After you have issued the
net radvd configure lan command, you enter the net-config [radvd] mode, and then
you can configure one keyword and associated parameter or associated keyword at a time in
the order that you prefer.
Format net lan ipv6 multi_homing delete <row id>
Mode net
Step 1 Format net radvd configure lan
Mode net
Step 2 Format enable {Y | N}
mode {Unsolicited-Multicast | Unicast-Only}
interval <seconds>
flags {Managed | Other}
preference {Low | Medium | High}
mtu <number>
life_time <seconds>
Mode net-config [radvd]
Keyword (might consist
of two separate words)
Associated Keyword to
Select or Parameter to Type
Description
enable Y or N Enables the RADVD process to allow stateless
autoconfiguration of the IPv6 LAN.
mode Unsolicited-Multicast
or Unicast-Only
Sets the advertisement mode:
• Unsolicited-Multicast. Allows unsolicited
multicast and unicast communication with the
hosts. Router advertisements (RAs) are sent to
all interfaces at the rate that is defined by the
interval keyword and parameter.
• Unicast-Only. Responds to unicast packet
requests only. No unsolicited packets are
advertised.