User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
53
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
net lan ipv6 multi_homing add
This command configures a new IPv6 alias, that is, a secondary IPv6 address. After you
have issued the net lan ipv6 multi_homing add command, you enter the
net-config [lan-ipv6-multihoming] mode, and then you can configure the secondary address
and IPv6 prefix length in the order that you prefer.
Command example:
FVS318N>
net lan ipv6 multi_homing add
net-config[lan-ipv6-multihoming]>
ip_address 2002::1006
net-config[lan-ipv6-multihoming]>
prefix_length 10
net-config[lan-ipv6-multihoming]>
save
Related show command: show net lan ipv6 multiHoming
net lan ipv6 multi_homing edit
This command configures an existing IPv6 alias, that is, a secondary IPv6 address. After you
have issued the net lan ipv6 multi_homing edit command, you enter the
net-config [lan-ipv6-multihoming] mode, and then you can configure the secondary address
and IPv6 prefix length in the order that you prefer.
Related show command: show net lan ipv6 multiHoming
Step 1 Format net lan ipv6 multi_homing add
Mode net
Step 2 Format ip_address <ipv6-address>
prefix_length <prefix length>
Mode net-config [lan-ipv6-multihoming]
Step 1 Format net lan ipv6 multi_homing edit
Mode net
Step 2 Format ip_address <ipv6-address>
prefix_length <prefix length>
Mode net-config [lan-ipv6-multihoming]