User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
52
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
net-config[lan-ipv6]>
dhcp domain name netgear.com
net-config[lan-ipv6]>
dhcp server_preference 236
net-config[lan-ipv6]>
dhcp dns_type useDnsProxy
net-config[lan-ipv6]>
dhcp rebind_time 43200
net-config[lan-ipv6]>
save
Related show command: show net lan ipv6 setup
net lan ipv6 pool configure
This command configures a new or existing IPv6 DHCP address pool. After you have issued
the net lan ipv6 pool configure command, you enter the net-config [lan-ipv6-pool]
mode, and then you can configure the IPv6 start and end addresses and the IPv6 prefix
length for the IPv6 pool in the order that you prefer.
Command example:
FVS318N>
net lan ipv6 pool configure
net-config[lan-ipv6-pool]>
start_address 2001::1025
net-config[lan-ipv6-pool]>
end_address 2001::1030
net-config[lan-ipv6-pool]>
prefix_value 56
net-config[lan-ipv6-pool]>
save
Related show command: show net lan ipv6 setup
net lan ipv6 pool delete <start ipv6-address>
This command deletes an IPv6 DHCP address pool by deleting its start address.
Related show command: show net lan ipv6 setup
Step 1 Format net lan ipv6 pool configure
Mode net
Step 2 Format start_address <ipv6-address>
end_address <ipv6-address>
prefix_value <prefix length>
Mode net-config [lan-ipv6-pool]
Format net lan ipv6 pool delete <start ipv6-address>
Mode net