User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
50
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Related show command: show net lan ipv4 multiHoming
net lan ipv4 multi_homing edit
This command configures an existing IPv4 alias, that is, a secondary IPv4 address. After you
have issued the net lan ipv4 multi_homing edit command, you enter the
net-config [lan-ipv4-multihoming] mode, and then you can configure the secondary address
and subnet mask in the order that you prefer.
Related show command: show net lan ipv4 multiHoming
net lan ipv4 multi_homing delete <row id>
This command deletes a secondary IPv4 address by specifying its row ID.
Related show command: show net lan ipv4 multiHoming
IPv6 LAN Commands
net lan ipv6 configure
This command configures the IPv6 LAN address settings and DHCPv6. After you have
issued the net lan ipv6 configure command, you enter the net-config [lan-ipv6]
mode, and then you can configure one keyword and associated parameter or associated
keyword at a time in the order that you prefer.
Step 1 Format net lan ipv4 multi_homing edit
Mode net
Step 2 Format ip_address <ipaddress>
subnet_mask <subnet mask>
Mode net-config [lan-ipv4-multihoming]
Format net lan ipv4 multi_homing delete <row id>
Mode net
Step 1 Format net lan ipv6 configure
Mode net