User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
45
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Related show command: show net lan ipv4 setup
net ethernet configure <interface name or number>
This command configures a VLAN for a LAN interface. After you have issued the net
ethernet configure command to specify a LAN interface, you enter net-config [ethernet]
mode, and then you can configure one keyword and associated parameter or associated
keyword at a time in the order that you prefer.
Command example:
FVS318N>
net ethernet configure eth0
net-config[ethernet]>
vlanid 12
net-config[ethernet]>
vlan-enable Y
net-config[ethernet]>
native-vlan N
net-config[ethernet]>
save
Note: To enter the net-config [ethernet] mode, you can issue the net
ethernet configure command with either an interface name
such as eth0 or an interface number such as 0.
Related show command: show net ethernet {interface name | all}
Step 1 Format net ethernet configure <interface name or number>
Mode net
Step 2 Format vlanid <number>
vlan-enable {Y | N}
native-vlan {Y | N}
Mode net-config [ethernet]
Keyword Associated Keyword to
Select or Parameter to Type
Description
vlanid number The VLAN ID.
vlan-enable Y or N Enables or disables the VLAN for this interface.
native-vlan Y or N Enables or disables the default (native) VLAN for this
interface.