User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
44
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
net-config[lan-ipv4]>
static address 192.168.1.1
net-config[lan-ipv4]>
static subnet_mask 255.255.255.0
net-config[lan-ipv4]>
dhcp mode DHCP-Relay
net-config[lan-ipv4]>
dhcp relay_gateway 10.172.214.198
net-config[lan-ipv4]>
proxy dns_enable N
net-config[lan-ipv4]>
inter_vlan_routing Y
net-config[lan-ipv4]>
save
Related show command: show net lan ipv4 setup
net lan ipv4 delete <vlan id>
This command deletes a VLAN by deleting its ID. You cannot delete VLAN 1, the default
VLAN.
Related show command: show net lan ipv4 setup
net lan ipv4 disable <vlan id>
This command disables a VLAN by specifying its ID. You cannot disable VLAN 1, the default
VLAN.
Related show command: show net lan ipv4 setup
net lan ipv4 enable <vlan id>
This command enables a VLAN by specifying its ID. VLAN 1, the default VLAN, is always
enabled.
Format net lan ipv4 delete <vlan id>
Mode net
Format net lan ipv4 disable <vlan id>
Mode net
Format net lan ipv4 enable <vlan id>
Mode net