User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
41
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N>
net ddns configure
net-config[ddns]>
enable DynDNS
net-config[ddns]>
hostname adminnetgear.dyndns.org
net-config[ddns]>
username jaybrown
net-config[ddns]>
password 4hg!RA278s
net-config[ddns]>
wild_flag_enable N
net-config[ddns]>
time_update_enable Y
net-config[ddns]>
save
Related show command: show net ddns setup
IPv4 LAN Commands
net lan ipv4 configure <vlan id>
This command configures a new or existing VLAN, that is, a VLAN ID and a VLAN profile.
After you have issued the net lan ipv4 configure command to specify a new or
existing VLAN ID, you enter the net-config [lan-ipv4] mode, and then you can configure one
keyword and associated parameter or associated keyword at a time in the order that you
prefer.
Keyword Associated Keyword to
Select or Parameter to Type
Description
enable Disable, DynDNS, TZO,
DNS_Oray, or 3322_DDNS
Enables or disables DDNS. Use the Disable
keyword to disable DDNS after you had first enabled
the service. The other keywords represent DDNS
service providers and are self-explanatory.
hostname host name Configures a host name (string) for a DDNS server.
username user name Configures a user name (string) for a DDNS server.
password password Configures a password (string) for a DDNS server.
wild_flag_enable Y or N Enables or disables the use of wildcards for DDNS.
time_update_enable Y or N Enables or disables the automatic update of the
DDNS service after 30 days.
Step 1 Format net lan ipv4 configure <vlan id>
Mode net