User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
40
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Related show commands: show net ipv6_tunnel setup and show net ipv6_tunnel status
net ipv6_tunnel six_to_four configure
This command enables or disables automatic tunneling, which allows traffic from an IPv6
LAN to be tunneled through an IPv4 WAN to reach an IPv6 network. After you have issued
the net ipv6_tunnel six_to_four configure command, you enter the
net-config [six-to-four-tunnel] mode, and then you can configure automatic tunneling.
Related show commands: show net ipv6_tunnel setup and show net ipv6_tunnel status
Dynamic DNS Commands
net ddns configure
This command enables, configures, or disables Dynamic DNS (DDNS) service. After you
have issued the net ddns configure command, you enter the net-config [ddns] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer.
Step 1 Format net ipv6_tunnel six_to_four configure
Mode net
Step 2 Format automatic_tunneling_enable {Y | N}
Mode net-config [six-to-four-tunnel]
Step 1 Format net ddns configure
Mode net
Step 2 Format enable {Disable | DynDNS | TZO | DNS_Oray | 3322_DDNS}
hostname <host name>
username <user name>
password <password>
wild_flag_enable {Y | N}
time_update_enable {Y | N}
Mode net-config [ddns]