User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
37
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N>
net wan wan1 ipv6 configure
net-config[wan1-ipv6]> isp_connection_type DHCPC
net-config[wan1-ipv6]> isp type dhcpc
net-config[wan1-ipv6]>
dhcpc stateless_mode_enable StatelessAddrAutoConfig
net-config[wan1-ipv6]> save
Related show commands: show net wan wan1 ipv6 setup and show net wan wan1 ipv6 status
net ipv6 ipmode configure
This command configures the IP mode. After you have issued the net ipv6 ipmode
configure command, you enter the net-config [mode] mode, and then you can configure
the IP mode. You can select support for IPv4 only or for both IPv4 and IPv6.
WARNING!
Changing the IP mode causes the wireless VPN firewall to reboot.
DHCPC
dhcpc stateless_mode_enable StatelessAddrAutoConfig
or
StatefulAddrAutoConfig
The type of DHCPv6 mode (stateless or
stateful). If you set the dhcpc
stateless_mode_enable keywords
to StatelessAddrAutoConfig, you
have the option to set the dhcpc
prefix_delegation_enable
keywords and associated parameter.
dhcpc
prefix_delegation_enable
Y or N If the dhcpc
stateless_mode_enable keywords
are set to
StatelessAddrAutoConfig, enables
or disables prefix delegation. Prefix
delegation allows the ISP’s stateful
DHCPv6 server to assign a prefix.
Step 1 Format net ipv6 ipmode configure
Mode net
Step 2 Format ip_type {IPv4_Only | IPv4/IPv6}
Mode net-config [mode]
Keyword (consists of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description