User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
33
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
dhcpc get_dns_from_isp Y or N Specifies whether or not the IP address is
dynamically received from the ISP. If you
select N, you need to issue the dhcpc
primary_dns keyword and enter the IP
address of the primary DNS server. For a
secondary DNS server, issue the dhcpc
secondary_dns keyword, and enter the IP
address.
dhcpc primary_dns ipaddress The IP address of the primary DNS server if
your IP address is not dynamically received
from the ISP.
dhcpc secondary_dns ipaddress The IP address of the optional secondary
DNS server if your IP address is not
dynamically received from the ISP.
PPPoE (These keywords consist of two separate words)
pppoe username user name The user name (alphanumeric string) to log
in to the PPPoE service, if required.
pppoe password password The password (alphanumeric string) to log in
to the PPPoE service, if required.
pppoe AccountName account name The PPPoE account name (alphanumeric
string).
pppoe DomainName domain name The PPPoE domain name (alphanumeric
string).
pppoe connectivity_type keepalive or
idletimeout
The type of PPPoE connection. If you select
idletimeout, you need to issue the
idle_time keyword and enter the idle
time-out in minutes.
pppoe idle_time minutes The idle time-out period in minutes, from 5 to
999 minutes.
pppoe connection_reset Y or N Specifies whether or not the PPPoE
connection is automatically reset. If it is
reset, you need to issue the reset_hour
and reset_min keywords and enter the
hour and minutes after which the connection
is reset. You also need to issue the
delay_in_reset keyword and enter the
number of seconds of delay.
pppoe reset_hour hour The hour at which the PPPoE connection is
reset.
pppoe reset_min minutes The minutes at which the PPPoE connection
is reset.
Keyword Associated Keyword to
Select or Parameter to Type
Description