User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Net Mode Configuration Commands
30
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Related show command: show net wan port_setup
IPv4 WAN Commands
net wan_settings wanmode configure
This command configures the mode of IPv4 routing between the WAN interface and LAN
interfaces. After you have issued the net wan_settings wanmode configure
command, you enter the net-config [routing-mode] mode, and then you can configure NAT or
classical routing.
WARNING!
Changing the mode of IPv4 routing causes all LAN–WAN and
DMZ–WAN inbound firewall settings to revert to default settings.
Related show command: show net wan_settings wanmode
net wan wan1 ipv4 configure
This command configures the IPv4 settings of the WAN interface. After you have issued the
net wan wan1 ipv4 configure command, you enter the net-config [wan1-ipv4] mode.
First, specify the ISP connection type (you can select only a single type). Then, for the
selected ISP connection type, configure one keyword and associated parameter or
associated keyword at a time in the order that you prefer. If you select a static ISP connection
type, there is no further configuration required.
Step 1 Format net wan_settings wanmode configure
Mode net
Step 2 Format type {NAT | Classical_Routing}
Mode net-config [routing-mode]
Step 1 Format net wan wan1 ipv4 configure
Mode net