User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Utility Commands
291
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Firmware Backup, Restore, and Upgrade Commands
util backup_configuration
This command backs up the configuration file of the wireless VPN firewall to a TFTP server.
util upload_configuration
This command uploads a previously backed-up configuration file of the wireless VPN firewall
from a TFTP server.
util firmware_upgrade
This command upgrades the firmware of the wireless VPN firewall from a TFTP server.
util reboot
This command reboots the wireless VPN firewall. It takes about 3 minutes for the wireless
VPN firewall to come back up.
Format util backup_configuration <destination file name> <tftp server address>
Mode util
Format util upload_configuration <source file name> <tftp server address>
Mode util
Format util firmware_upgrade <source file name> <tftp server address>
Mode util
Format util reboot
Mode util