User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
290
10
10. Utility Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
Util mode. The chapter includes the following sections:
• Overview Util Commands
• Firmware Backup, Restore, and Upgrade Commands
• Diagnostic Commands
Overview Util Commands
Enter the util ? command at the CLI prompt to display the description of the utility
commands in the util mode. The following table lists the commands in alphabetical order:
Table 19. Utility commands in the util mode
Command Name Purpose
util backup_configuration Back up the configuration file of the wireless VPN firewall to a
TFTP server.
util dns_lookup Look up the IP address of a domain name.
util firmware_upgrade Upgrade the firmware of the wireless VPN firewall from a TFTP
server.
util ping Ping an IP address.
util ping_through_vpn_tunnel Ping a VPN endpoint IP address.
util reboot Reboot the wireless VPN firewall.
util restore_factory_defaults Restore the wireless VPN firewall to factory default settings.
util routing_table_ipv4 Display the IPv4 routing table.
util routing_table_ipv6 Display the IPv6 routing table.
util traceroute Trace a route to an IP address.
util upload_configuration Upload a previously backed-up configuration file of the wireless
VPN firewall from a TFTP server