User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
282
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Tue Apr 10 12:27:25 2012 (GMT -0700): [FVS318N] [IKE] INFO: Sending
Informational Exchange: notify payload[10637]
SSL VPN Show Commands
show vpn sslvpn client
This command displays the SSL VPN client ranges and configurations:
SSL VPN Client(IPv4)
____________________
Enable Full Tunnel Support: No
DNS Suffix:
Primary DNS Server: 192.168.10.5
Secondary DNS Server: 192.168.10.6
Client Address Range Begin: 192.168.200.50
Client Address Range End: 192.168.200.99
SSL VPN Client(IPv6)
____________________
Enable Full Tunnel Support: No
DNS Suffix:
Primary DNS Server: 192.168.10.5
Secondary DNS Server: 192.168.10.6
Client Address Range Begin: 4000::1000:2
Client Address Range End: 4000::1000:50
show vpn sslvpn logs
This command displays the SSL VPN logs:
Fri Dec 9 20:19:03 2011(GMT) [FVS318N][System][SSLVPN] SSL_INFO :user admin2 is
Logged-Out successfully from host 10.116.205.103
Sat Dec 10 09:12:50 2011(GMT) [FVS318N][System][SSLVPN] SSL_INFO : Login
Successful for Local Admin user admin2 from host 10.116.205.103
Sat Dec 10 14:07:32 2011(GMT) [FVS318N][System][PLATFORM]
platformHandleDBUpdate:SSLVPNUserLoginPolicyDefinedBrowser op=18 row=2
Sat Dec 10 14:12:10 2011(GMT) [FVS318N][System][PLATFORM]
platformHandleDBUpdate:SSLVPNUserLoginPolicyDefinedAddress op=18 row=1
Sat Dec 10 14:12:26 2011(GMT) [FVS318N][System][SSLVPN] Edit operation done on
user PeterBrown