User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
280
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Wireless Statistics Commands
show dot11 statistics
This command displays the cumulative wireless traffic statistics for all wireless profiles (note
that the profiles are indicated by ap1, ap2, ap3, and so on):
Wireless Statistics
___________________
AP Name Radio PktRx PktTx ByteRx ByteTx ErrRx ErrTx DropRx DropTx MCast #coll
_______ _____ _____ _____ ______ ______ _____ _____ ______ ______ _____ _____
ap1 1 0 0 0 0 0 0 0 83 0 0
ap2 1 0 0 0 0 0 0 0 0 0 0
ap3 1 0 0 0 0 0 0 0 80 0 0
VPN Settings (VPN Mode) Show Commands
This section contains the following subsections:
• IPSec VPN Show Commands
• SSL VPN Show Commands
• SSL VPN User Show Commands
• RADIUS Server Show Command
• L2TP Server Show Commands
IPSec VPN Show Commands
show vpn ipsec ikepolicy setup
This command displays the IKE policies:
List of IKE Policies
____________________
Name Mode Local ID Remote ID Encryption Authentication DH Group
_________________ __________ ______________________ _____________ __________ ______________ ____________
iphone aggressive 10.139.54.228 0.0.0.0 AES-128 SHA-1 Group 2 (1024 bit)
FVS318N-to-Peer44 main fe80::a8ab:bbff:fe00:2 peer44.com 3DES SHA-1 Group 2 (1024 bit)
FVS-to-Paris main 10.139.54.228 10.112.71.154 3DES SHA-1 Group 2 (1024 bit)