User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
28
3
3. Net Mode Configuration Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
net mode. The chapter includes the following sections:
• General WAN Commands
• IPv4 WAN Commands
• IPv6 WAN Commands
• IPv6 Tunnel Commands
• Dynamic DNS Commands
• IPv4 LAN Commands
• IPv6 LAN Commands
• IPv4 DMZ Setup Commands
• IPv6 DMZ Setup Commands
• IPv4 Routing Commands
• IPv6 Routing Commands
IMPORTANT:
After you have issued a command that includes the word
configure, add, or edit, you need to save (or cancel) your
changes. For more information, see Save Commands on page 13.
General WAN Commands
net wan port_setup configure
This command configures the MTU, port speed, and MAC address of the wireless VPN
firewall. After you have issued the net wan port_setup configure command, you
enter the net-config [port_setup] mode, and then you can configure the MTU, port speed,
and MAC address.
Step 1 Format net wan port_setup configure
Mode net