User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
279
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
PktTx: 0
ByteRx: 0
ByteTx: 0
ErrRx: 0
ErrTx: 0
DropRx: 0
DropTx: 11301
MCast: 0
#Coll: 0
Connected Clients
_________________
show dot11 acl <profile name>
This command displays the ACL policy and MAC addresses for the specified profile:
Default ACL Policy
__________________
ACL Policy Status: Allow
List of MAC Address
___________________
_________________
a1:23:04:e6:de:bb
c2:ee:d2:10:34:fe
show dot11 wps
This command displays the WPS configuration:
Access Point Name: ap1
WPS Enabled: Y