User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
278
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Profile Show Commands
show dot11 profile [profile name]
This command displays basic information for all profiles or basic and advanced information
for a specified profile:
• All profiles:
FVS318N>
show dot11 profile
Status Profile Name SSID Broadcast Security Encryption Authentication Active Time Start Time Stop Time
________ ____________ _________ _________ ________ __________ ______________ ___________ __________ _________
Enabled default1 FVS318N_1 Y WPA+WPA2 TKIP+CCMP PSK Disabled - -
Disabled 1st_Floor WorkToDo Y WPA+WPA2 TKIP+CCMP PSK Enabled 7:0 AM 8:0 PM
• A specified profile
FVS318N>
show dot11 profile 1st_Floor
Profile Configuration
_____________________
Profile Name: 1st_Floor
SSID: WorkToDo
Broadcast SSID: Enabled
Security: WPA+WPA2
Authentication: PSK
Encryption: TKIP+CCMP
WPA Password: **********
Profile Advanced Configuration:
Association Timeout Interval (in Seconds): 10
Authentication Timeout Interval (in Seconds): 10
Group Key Refresh Interval (in Seconds): 3600
PMKSA LifeTime (in Seconds): 3600
802.1X Re-authentication Interval (in Seconds): 3600
show dot11 profile status <profile name>
This command displays traffic statistics for the specified profile (note that the profile is called
an access point and that, in this example, it is indicated by ap2):
Access Point Status
___________________
AP Name: ap2
Radio: 1
PktRx: 0